1 General Information
1.1 Document Focus
This document describes how to operate and maintain eSite Modular. It focuses on eSite Web, eSite Tools and the settings that can be done to the associated systems. For optional eSite accessories and installation of the associated systems see the Installation manual.
1.2 Target Group
This document is intended for the personnel that will operate and maintain eSite Modular. Such personnel can work both on site and from a distance via eSite Tools. The personnel must have sufficient basic skills and training.
1.3 Warning Levels
Warning
Highlights hazards that can result in personal injuries, as well as serious damage to mechanical structures and equipment
Caution
Highlights hazards that can result in damage to the equipment.
Note
Highlights general useful information.
Read
Highlights that there is information to read in addition to this document. That information must be considered when operating the device or control.
1.4 Trademarks
eSite™ and eSite Tools™ are registered trademarks of eSite Power Systems AB (publ) and will be referred to here after as eSite and eSite Tools.
1.5 Available Product Documentation
Product Description
Installation Guide
Operation Manual
1.6 Abbreviations and Definitions
A
Ampere
Ah
Ampere hour
AC
Alternating Current
ATS
Automatic Transfer Switch
BMS
Battery Monitoring System
BMU
Battery Monitoring Unit
°C
Degree Celsius
CAN
Controller Area Network
CE
Conformité Européenne
DC
Direct Current
EC
European Conformity
EMC
Electromagnetic Compatibility
GND
Electrical Ground
HP
High Priority
Hz
Hertz
kW
Kilowatt
LP
Low Priority
MCB
Miniature Circuit Breaker
MPPT
Maximum Power Point Tracker
MHz
Megahertz
N/A
Not Available
NTP
Network Time Protocol
PVC
Polyvinyl chloride
RMS
Remote Monitoring System
SCR
Silicone controlled rectifiers
SoC
State of charge
SIM
Subscriber Identity Module
V
Volt
V
AC Volts of Alternating Current
V
DC Volts of Direct Current
W
Watt
WLAN
Wireless Local Area Network
Associated systems
The term associated systems refers to parts or systems outside eSite Modular, e.g. the battery bank, the genset, the grid and the solar arrays.
Customer load
The customer load is the equipment that is supplied with power from eSite Modular.
eSite Tools
eSite Tools is a Remote Monitor and Control System that monitors several eSite Modular in a network. eSite Tools can be used to view the status of all sites in a network and to create a variety of reports. It can also be used for software downloading and for configuration changes.
eSite Web
eSite Web is the local eSite Modular user interface. It is used to monitor data and configure the system on the site.
Tenant
The tenant is the telecom operator that receives power through eSite Modular. Each tenant can connect both high priority load and low priority load. The power consumption can be separately measured for the connected tenants.
Last updated
Was this helpful?